Serving Apache Junction & Surrounding Areas Call Now: (833) 713-2101
Expansion Tank Service service

The small tank behind the big problem

Expansion Tank Service in Apache Junction, AZ

That little tank hanging above your water heater is the expansion tank, and when its internal bladder fails, pressure spikes have nowhere to go — so your TPR valve starts discharging and your plumbing takes a beating. Half the ‘mystery’ TPR drips we see trace back to this one component. Call (833) 713-2101. Certified Professional, Licensed & Insured Team.

Call Now(833) 713-2101
  • ✓ Certified Professional
  • ✓ Licensed & Insured Team
  • ✓ No-Nonsense Diagnosis
  • ✓ Clear Explanations

About this service

What the expansion tank does — and how it dies

Water expands when heated. In a closed plumbing system (which most homes with a pressure regulator or check valve have), that extra volume has nowhere to go — so pressure spikes every heating cycle. The expansion tank absorbs it: water pushes against a rubber bladder with an air cushion behind it. When the bladder ruptures or the air charge leaks out, the tank goes waterlogged and stops absorbing anything. Pressure spikes return, the TPR valve weeps to relieve them, and every joint in the house gets hammered.

The tell is simple: tap the tank. A healthy one sounds hollow at the top; a waterlogged one thuds solid, and may feel heavy. Replacement is quick, but the detail that matters is the pre-charge — the new tank’s air pressure must match your home’s static water pressure (normal is 40–60 psi), set with the system depressurized. Wrong pre-charge and the new tank barely works. If your TPR valve drips regularly, check the expansion tank before you blame the valve — or call (833) 713-2101 and we will check both.

Call Now

Expansion Tank Service in Apache Junction

How it works

What to expect

  1. Test bladder and air charge

    Tap test, pressure check with the system drained down — we confirm whether the tank is waterlogged or just under-charged.

  2. Measure your static pressure

    A gauge on the system tells us the number the new tank’s pre-charge must match.

  3. Install the replacement

    Correctly sized for your water heater, supported properly — these tanks are heavy when full and should not hang by the pipe alone.

  4. Set pre-charge precisely

    Air charge matched to your static pressure with the system depressurized. This step is the whole job, really.

  5. Verify the system calms down

    Heating cycle run, pressure watched, TPR valve dry. The drip should be gone because the cause is gone.

FAQ

Expansion Tank Service questions

How do I know if my expansion tank is bad?

Tap it: hollow ring at the top is good, a dull thud means it is waterlogged. A TPR valve that drips after every heating cycle is the other classic symptom.

Can I just add air to the old tank?

If the bladder is intact but the charge leaked down, sometimes. If the bladder ruptured — the common failure — no amount of air fixes it. We test before we replace.

Why does the pre-charge pressure matter?

The air cushion only absorbs expansion if it is set to your home’s static pressure. Set wrong, the tank does almost nothing and the TPR keeps dripping.

Related services

You may also need

TPR Valve Replacement

That little side pipe dripping? Your TPR valve is either worn out or warning you about pressure. We figure…

Water Heater Replacement

When the tank shell itself has failed, honest replacement beats another repair. We size the new unit to your…

Need help right now?

Tell us where the water is and what kind of heater you have — we take it from there. Call Water Heater Leak Repair Solutions for water heater leak repair in Apache Junction, AZ.

Call Now

Call Now

(833) 713-2101

Call Now