TPR Valve Replacement
That little side pipe dripping? Your TPR valve is either worn out or warning you about pressure. We figure…

The honest call
Nobody wants to hear ‘replace it.’ So here is our rule: we recommend replacement only when the tank itself is done — corroded through, cracked, or leaking from the shell — or when the unit’s history says another repair is patching a finished tank. When that is the call, we size the new unit to your household and install it clean. Call (833) 713-2101. Certified Professional, Licensed & Insured Team.
About this service
Valves fail, fittings weep, gaskets drip — all fixable. The tank shell is different. Once the steel is rusted through or cracked, there is no repair that holds; the corrosion is systemic, not local. The signs: water weeping from the tank body itself (not a fitting, not a valve), rust streaks running down the jacket from under the top, or a base that stays damp no matter what gets tightened. In hard-water country, tanks typically last 8–20 years depending on type and maintenance — neglected ones in mineral-heavy water land on the short end.
Replacement done right is more than swapping boxes. We size the unit to your household’s actual hot-water use, set the new connections with proper dielectric unions, evaluate the expansion tank (a new heater on a dead expansion tank just moves the problem), confirm venting on gas models, and haul the old unit away. Thermostat set around 120°F, everything pressure-tested, hot water confirmed. If your tank is weeping from the shell, shut the water and heat source off and call (833) 713-2101 for the straight answer.

How it works
We verify the leak is from the shell — not a fitting, valve, or condensation — before anyone talks replacement.
Tank capacity and recovery matched to how many people actually use hot water, not just what was there before.
Drained, disconnected, and hauled away. The area gets cleaned up, not left with a rust ring and debris.
New supply connections, dielectric unions, expansion tank evaluated, proper venting on gas models, drain pan where it belongs.
Filled, fired, pressure-tested, TPR checked, thermostat at 120°F, hot water at the tap before we leave.
FAQ
The dividing line is the tank shell: water weeping from the steel body itself, or rust-through at the seams, means replacement. Failed valves, fittings, and gaskets mean repair.
Typically 8–20 years depending on the type, with hard water and skipped maintenance pulling toward the short end. Annual flushing and anode-rod checks are what buy the extra years.
Yes — that is the whole point of an honest diagnosis. If a valve or fitting fixes it, we fix it. Replacement is only the recommendation when the tank is done.
Related services
That little side pipe dripping? Your TPR valve is either worn out or warning you about pressure. We figure…
The drain valve at the tank base is the first thing hard water kills. We swap failed plastic and crusty brass…
Wet around the top of the tank? Inlet and outlet fittings loosen and corrode with years of heat cycling. We…
No tank to fail, but tankless units still leak: condensate lines, isolation valves, heat-exchanger seals. We…
A pan under the tank with a real drain line turns a future leak into a non-event. We size it right, pitch the…
Water plus a gas burner demands respect. We shut the gas down first, fix the water-side leak, then verify…
Element gaskets and thermostat covers are the electric-only leak points. Power off at the breaker, gaskets…
A dead expansion tank is why TPR valves drip and drip. We test the bladder and air charge, replace failed…
The shutoff on your cold-water inlet is your first defense in a leak — but old gate valves seize solid. We…
Some leaks cannot wait: water spreading across the floor, a burst fitting, a tank discharging heavily. Here…