TPR Valve Replacement
That little side pipe dripping? Your TPR valve is either worn out or warning you about pressure. We figure…

Your first line of defense
The shutoff valve on the cold-water inlet is the thing you reach for when water is going where it should not. Old gate valves seize, handles snap off, and half-closed valves weep. If yours has not moved in ten years, assume it will not move when you need it. We replace them with quarter-turn ball valves: one motion, fully closed, done. Call (833) 713-2101. Certified Professional, Licensed & Insured Team.
About this service
Here is the scenario we see too often: a homeowner spots a leak, runs to the heater, grabs the shutoff — and it will not budge. Years of mineral-heavy water have frozen the gate valve solid, or the handle crumbles in their hand. Now a ten-minute fix becomes a scramble for the main house valve while water keeps flowing. In desert homes where heaters sit in garages full of stored belongings, those extra minutes matter.
A quarter-turn ball valve solves it: a lever you flip 90 degrees, positive shutoff you can feel, and a design that does not seize the way gate valves do. It is a small job with an outsized payoff — every future leak, flush, or repair starts with a valve that actually works. Go try yours right now. If it is stuck, stiff, or weeping around the stem, call (833) 713-2101 before you need it in a hurry.

How it works
We see what you are working with: seized gate valve, weeping stem packing, or a handle that is barely hanging on.
Main house water off, heater depressurized, heat source off — the safe way to swap an inlet valve.
Full-port brass ball valve on the cold-water inlet. One lever, positive close, no seizing.
While we are at the inlet, we inspect the union and flex connector — the neighbors that fail next.
We cycle the new valve under pressure: full open to full closed, dry stem, instant shutoff.
FAQ
Do not force it; old gate valves snap. Use the main house shutoff for now, and have the heater’s valve replaced with a quarter-turn ball valve.
Gate valves use a threaded stem that seizes with mineral buildup. Ball valves use a lever and a rotating ball — one quarter-turn, fully open or fully closed, and they stay workable for years.
It is a warning. Stem-packing weeps get worse, and a valve that weeps often will not fully close either. Replace it on your schedule, not the leak’s.
Related services
That little side pipe dripping? Your TPR valve is either worn out or warning you about pressure. We figure…
The drain valve at the tank base is the first thing hard water kills. We swap failed plastic and crusty brass…
Wet around the top of the tank? Inlet and outlet fittings loosen and corrode with years of heat cycling. We…
No tank to fail, but tankless units still leak: condensate lines, isolation valves, heat-exchanger seals. We…
A pan under the tank with a real drain line turns a future leak into a non-event. We size it right, pitch the…
Water plus a gas burner demands respect. We shut the gas down first, fix the water-side leak, then verify…
Element gaskets and thermostat covers are the electric-only leak points. Power off at the breaker, gaskets…
A dead expansion tank is why TPR valves drip and drip. We test the bladder and air charge, replace failed…
Some leaks cannot wait: water spreading across the floor, a burst fitting, a tank discharging heavily. Here…
When the tank shell itself has failed, honest replacement beats another repair. We size the new unit to your…